|
Who's Online
There currently are 5624 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Having bought a pre-owned Sony FM stereo tuner through eBay, it came without any manuals. It soon became clear that to get the best from this excellent tuner I needed a decent manual because much of the operation was not intuitive to a newboy to hi fi like me. I managed to download the official Sony multi-lingual manual from Owner-Manuals.com with no problem at all - a really quick and easy service. I'm very glad I did because I found out all the operations of the tuner and was then able to not only set it up quickly but also to get much more from it that poke-and-hope trialling would ever achieve. In my book $4.99 very well spent.
;
This manual is immaculate in it's accuracy. Everything is written very clearly and easy to understand. Written by a professional who wants to convey a clear and easy to understand message!!
;
This Manual (as downloaded) is both informative and comprehensive and has proved to be extremely useful. thoroughly recommended.
;
everything is ok, thank you very much! Product is good, no problems with download!
;
Great site, I always find all the manuals I need and i can't find anywhere else. PDF for the Sony PCM 3348 is complete and scan is good quality. Thank you!
Upgrading simply means replacing those electronic components which tend to fail if the receiver has not been kept reasonably cool. If you are familiar with the use of a soldering iron and the safety precautions required when working on mains-powered equipment then you can order an upgrade kit from: Faults If your receiver appears to be faulty, the first thing you should do is to unplug it from the mains power for a few minutes. If this cures the fault then it was probably caused by a mains surge. Make sure that no wires inside the mains plug are loose � all screws tight � and that the outer plastic sheath of the mains cable is clamped firmly where it enters the plug. Read the section about mains surges. If unplugging it for a few minutes does not cure the fault then overheating may be to blame. Try leaving the receiver unplugged for an hour or two. If this cures the fault temporarily then it is suffering from an intermittent fault and must be repaired and upgraded before it becomes worse. No audio at all (no hiss): often caused by selecting �MAC� instead of �PAL� in the menu. Read the relevent section and make sure that �PAL� is selected. No audio except hiss is usually caused by a badly soldered joint on the chip beneath the main circuit board. No decoder messages: if unplugging does not cure this then the decoder box inside may need to be repaired Sparkly pictures can have a multitude of causes. If sparklies are both black and white then a poor signal is the cause. Ensure VIDEO DEVIATION is set to NARROW. The tuner module may be at fault but it is possible that the dish has moved out of line or the cable or LNB are faulty. Of course, very heavy rain or snow can also cause this fault, as can anything obstructing the dish (such as a tree). If the sparklies are only black or only white then the tuning is incorrect. Make sure that the affected channels have the correct frequency set then try the Global FINE TUNE setting for the best picture quality on all channels. Red and green lights flashing on and off simultaneously: indicates no voltage going to the LNB or a short circuit on the cable or screw connector. Try unplugging the receiver from the mains, disconnecting the screw connector and re-applying mains power. If the receiver will come on (green light by itself) and you can change channel (but no picture of course) then there is probably a short circuit in the screw connector, the cable or the LNB on the dish. However, if both lights continue to flash with the cable disconnected, you probably have a faulty receiver. Page 12
|
|
|
> |
|